RC Arms with Ballistic Joints

Anyone used the ballistic fab 2.63" forged joint with their Rough Country LCA's? I see you can get the 1.25"-12 right hand thread on the 2.63" joint, but i'm just curious about fitment issues in the CA mount on the axle....if there is any.

Or will the 3" joint fit?

Measure the width (or get someone else to do it if you don't own it yet) of the RC bracket and that should give you your answer. If the joint width and thread count are the same, of course it'll work. Johnny joints or 1.25" heims could too.