RE lower control arms

Just picked up a used set of what i think are rubicon Express lower control arms. they are adjustable but anything over 15 inches and they have some wiggle in them around where the threads are. Should i grease them and let them go or pickup a new set?

I realize they dont have a bend but i got them for 30 bucks

Those are first gen rough country, I ran them for a while with no issues.

ok sweet, was 30 bucks a decent deal for them?

yes

My old school Teraflex LCA's are built like that, only the frameside end uses a stock LCA bushing. Has the same offset rubber bushing, mine were missing when I got but the ID of the sleeve was 1.5" so I just used the bushing centers from Ruffstuff for a couple of bucks. Mine can extend out to at least 18-20" before getting loose-ish. They are at 16.5" right now, greased and tight.

yeh these are old and havent been greased in a while i think thats what the looseness is.