muddypunk
TOOL
- Location
- Coupeville Whidbey Island washington
Ok so I had to replace my UCA bushings but this time they were so bad the steel bolt tube fell out and Ive tried burning it out but now Ive got like a 1/4 inch of gumby rubber still in the bushing.Im going to poly bushings so I need to keep the Sleeve in the axle so what can I do to remove this excess rubber ???? Im stumped because there isnt enough room to get my Ball joint press up there without pulling my spring and I dont think the press will get the rubber out .Any advise would much Appreciated
Thanx:dunno:
Thanx:dunno: