So i just went and purchased a 96 2door 4cyl 4x4 xj went to drive it, it starts good but i couldn put it in gear the clutch would not grab checked the resevoir it was empty put some in and the clutch grabbed a little. my question is this. what would be the wisest thing to do here and how? should i change the slave and master cylinder how can i bleeed the system? or just change out everything clutch and both slave and master? After i drove it around the block with the clutch beig a pain to shift in and out of gear i decided to buy it was really jerky on take off also not sure if any one can help with this. thanks in advance