-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
injector harness
- Thread starter spring50
- Start date
- Location
- MilkyWay Galaxy
Junk yard pull is your best bet!!!!
Wow, I just may have hit the jack pot folks. Lets sticky these links (this thread, post)!!!!
http://www.picowiring.com/pdf/Cat-35-38.pdf
http://www.myvirtualpaper.com/doc/carquest/carquest-engine-controls-catalog/2010111901/354.html#354
5-90 might be able to tell us which one fits Renix, (most other Renix connectors were GM)
Or just buy this one!!!
http://www.autozone.com/autozone/pa...vee1?counter=0&itemIdentifier=429330_49141_0_
Wow, I just may have hit the jack pot folks. Lets sticky these links (this thread, post)!!!!
http://www.picowiring.com/pdf/Cat-35-38.pdf
http://www.myvirtualpaper.com/doc/carquest/carquest-engine-controls-catalog/2010111901/354.html#354
5-90 might be able to tell us which one fits Renix, (most other Renix connectors were GM)
Or just buy this one!!!
http://www.autozone.com/autozone/pa...vee1?counter=0&itemIdentifier=429330_49141_0_
Matthew Currie
NAXJA Member #760
- Location
- Vermont, land of big clay
If I were doing this I'd go to a junkyard and try to find the harness from an 89 or 90. All the electronics and connectors are the same, but the harness is much neater and more direct, avoiding the bulkhead connector and passing straight through the firewall to the ECU. Actually, it's two separate harnesses, I think, one for the fuel injection itself, and the other for all the other electronics.
