hawk_sixsix
NAXJA Forum User
- Location
- L.I. New York
In a perfect world, I'd install my new IRO 3.5" leafs and Advance Adapters SYE / Tom Woods CV driveshaft and THEN take measurements, but my work and liesure timelines dictate otherwise.
Done plenty of searching and reading here on
on the issue ("all Jeeps are different", got it)... but hoping someone had a similar setup and can tell me what degree shims they used. Just want to put it all together at once to get it going; if I'm off by a degree or two I can rework it later on.
97 XJ, AX15, 231 TC, 8.25 rear
Done plenty of searching and reading here on
on the issue ("all Jeeps are different", got it)... but hoping someone had a similar setup and can tell me what degree shims they used. Just want to put it all together at once to get it going; if I'm off by a degree or two I can rework it later on.97 XJ, AX15, 231 TC, 8.25 rear
