BPB
NAXJA Forum User
- Location
- Battle Ground, Washington
Is anyone running a fuel cell? If so what fuel pump are you running and were you able to mke the factory fuel guage work?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
pump for fuel cell
- Thread starter BPB
- Start date
BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
This is what I am using.
http://www.polyperformance.com/shop/Gen-Right-Jeep-TJ-LJ-XJ-Aluminum-Pump-Rings-p-17431.html
http://www.polyperformance.com/shop/Gen-Right-Jeep-TJ-LJ-XJ-Aluminum-Pump-Rings-p-17431.html
My setup:
Out of 70-micron Walbro pickups/filters from the cell --> Earl's Shut-Off Valve --> 4060FI pump --> 4305M return reg --> EITHER back through another Shut-Off Valve and into the tank OR onto a 10-micron filter --> pressure gauge then finally into the fuel rail.
My dash gauge isn't hooked to anything, so it just stays on 'E'. It is a trail only rig so I don't really have a need for a gauge, simple enough to just pop the top and look inside.
Out of 70-micron Walbro pickups/filters from the cell --> Earl's Shut-Off Valve --> 4060FI pump --> 4305M return reg --> EITHER back through another Shut-Off Valve and into the tank OR onto a 10-micron filter --> pressure gauge then finally into the fuel rail.
My dash gauge isn't hooked to anything, so it just stays on 'E'. It is a trail only rig so I don't really have a need for a gauge, simple enough to just pop the top and look inside.
- Location
- NE Texas
Hell, Now i'm interested in going with a Cell!
MoparManiac
NAXJA Forum User
- Location
- Amherst, NH
RCI2161A with YJ pump assembly (I have an OBD-1 MJ). Cell has a built in check valve too.
No pickups inside the cell, works just fine as long as there's more than 1-2 gals left.
Fuel gauge doesn't work quite right. Not sure if the float is stuck on the existing return tube or not, never bothered to check.
Mounted in the bed, as far foward to the cab as possible.
No pickups inside the cell, works just fine as long as there's more than 1-2 gals left.
Fuel gauge doesn't work quite right. Not sure if the float is stuck on the existing return tube or not, never bothered to check.
Mounted in the bed, as far foward to the cab as possible.
