Drive shaft angle

I called HAD and they said they recomend "2 degrees down" now to me that sounds like the pinion should be angles 2 degrees below the tcase output.

To me it would make more sense if it was aimed 2 degrees above but I don't know shhi.
So which would 2 degrees down be?

Yup 2 degrees below tcase output.

It's to account for pinion wrap during acceleration.

If you have a four link with hard joints all around I would think you could get away with less but I'm not sure.

Ahh ok thanks

Sent from my T-Mobile G2 using Tapatalk