Dana 44 U Joints, Yoke, Driveshaft ?

I got a Driveshaft made for a ZJ 98 5.9, has a Dana 44a Axle i believe.

The issue is the ujoints on the Driveshaft on both ends are the same style while on the axle end it seems the cap size is different. Fits on the Tcase end, not Axle.

Instead of sending back the shaft, can the yoke be changed or something on the axle ?

Ideas, suggestion, greatly appreciated.

Pete

That seems odd,but you can probably find a "cross" joint(xxxx/1310) if you figure out what the ZJ joint is.