cuchulainn
NAXJA Forum User
- Location
- usa
Has anyone tried to shoehorn a later model hemi from a grand cherokee into a XJ?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
grand cherokee hemi
- Thread starter cuchulainn
- Start date
OK Cherokee
NAXJA Forum User
- Location
- Tulsa, OK
Some people feel the need to put a "Jeep" motor into a Jeep.
I'd go LS, if it was me....
I'd go LS, if it was me....
9T3XJ
NAXJA Forum User
- Location
- FoCo, Colorado
If you search I'm pretty sure it's been covered on here before. From my understanding the Hemi is a very wide motor and it would take a lot of work to get it to fit.
Darky
NAXJA Forum User
- Location
- 29 Palms, CA
I'd love to do a Hemi/545RFE swap, but would likely go LS instead since it's been done and I can copy someone else's build...
- Location
- WA state
Probably cheaper, more power, and better mileage too.
Darky
NAXJA Forum User
- Location
- 29 Palms, CA
If I win the lotto, I'm getting an LS9. Maybe two. Make one into a coffee table with a glass top. 
cuchulainn
NAXJA Forum User
- Location
- usa
I am not too informed about motors what is an LS?
9T3XJ
NAXJA Forum User
- Location
- FoCo, Colorado
Gen III and IV small block Chevy motors, aluminum heads, most have aluminum blocks. Commonly found in Vettes, Cameros, GTOs, etc...
