bump stop install help needed asap

So started to install my front bumps. Uppers are pollyurathane and was told they fit into stock holder well they don't fit any ideas tips or tricks please call me 7143667726

do you have the screw in type?

How much too large are they?

If its just too snug of a fit, you can soften them up by putting them in hot water.

I looked on the web looks like they are waaaay to big were gona cut them down

90 scew in

I had the same problem withmy 91. Stock poly replacement were to big. Ended up putting a grinder in a vice and trimmed them down, but keeping them as round as possable. Put some grease on them and use a bottle Jack between spring bucket and bump stop. Suckers will pop right in.