truck7575
NAXJA Forum User
- Location
- georgetown
Does anybody know where I can find specific gear installation instructions on the 29 spline Chrysler 8.25 rear axle. With pictures & specs would great!
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Gear installation question
- Thread starter truck7575
- Start date
RCP Phx
NAXJA Forum User
- Location
- Phoenix,Az
Most of the info you will need will come with your gears,the rest is generic anyway.
joe_peters
NAXJA Forum User
- Location
- Grants Pass, OryGun
Here is some info: http://www.cherokeeforum.com/f51/chrysler-8-25-gear-install-3374/
Found it using Google.
Found it using Google.
tbburg
NAXJA Forum User
- Location
- Scottsdale AZ
Quick side note: an easier way to make the lash adjustment tool is to weld a 36mm nut onto a 3 foot piece of hex or square stock(hex allows you to use a socket wrench to adjust)
Source for 36mm nut: front spindle nut from a junk yard or parts store(don't rob your front axle
)
Source for 36mm nut: front spindle nut from a junk yard or parts store(don't rob your front axle
)RCP Phx
NAXJA Forum User
- Location
- Phoenix,Az
Quick side note: an easier way to make the lash adjustment tool is to weld a 36mm nut onto a 3 foot piece of hex or square stock(hex allows you to use a socket wrench to adjust)
Source for 36mm nut: front spindle nut from a junk yard or parts store(don't rob your front axle
Or a brand new VW gland nut-5$max!Whatever you buy,make sure and polish all the shoulders smooth so you dont nick the bearings or the seals!