SeansXJ
NAXJA Forum User
- Location
- Antelope, Ca or on the Rubicon
1990 4.0 auto
just installed the axles in my sig.. 4.56s locked F/R
for some odd reason when i put it in drive it starts out in 3rd or 4th not sure, but its no bueno! I can start in 1st no problem and shift into gears fine. Its just when i start in D or 3rd. i never touched the tranny, dropped the old axles and put in the new..i also swapped in a new column... all i can think is just out of coincidence something went wrong with a solenoid?..never had any tranny problems till this swap so im at a point where my knowledge ends.
any ideas?
thanks!
Sean
just installed the axles in my sig.. 4.56s locked F/R
for some odd reason when i put it in drive it starts out in 3rd or 4th not sure, but its no bueno! I can start in 1st no problem and shift into gears fine. Its just when i start in D or 3rd. i never touched the tranny, dropped the old axles and put in the new..i also swapped in a new column... all i can think is just out of coincidence something went wrong with a solenoid?..never had any tranny problems till this swap so im at a point where my knowledge ends.
any ideas?
thanks!
Sean
