ibobmc
NAXJA Forum User
- Location
- Middle coast of CA
Hi, I have a '99 XJ that I just purchased. The ball joints, tie rods, etc. need to be replaced so I am going to install a 3.5" lift at the same time. I am going to do the work and have a shop perform the front end alignment.
In talking with one shop, they suggested I install off set ball joints because the standard ball joints don't provide enough caster. Is this true for such a small lift? What kind of castor measurements are folks getting with standard ball joints and 3.5" or 4.5" lifts?
I have been through pages and pages of searchs on this forum and others but can't find anything addressing this subject.
Thanks for helping, Bob.
In talking with one shop, they suggested I install off set ball joints because the standard ball joints don't provide enough caster. Is this true for such a small lift? What kind of castor measurements are folks getting with standard ball joints and 3.5" or 4.5" lifts?
I have been through pages and pages of searchs on this forum and others but can't find anything addressing this subject.
Thanks for helping, Bob.