• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

HID install question

PM TCM GLX and Tony will set you up.
 
did that just happen?
 
djblade311 said:
you need to buy new housings. I'm running these: http://www.quadratec.com/products/97009_02.htm
Click to expand...

Are those HID's or did you only use the housing and then replace the inside with an HID set up? Sorry if this is a stupid question, but I know little about HID's and I am thinking about doing the upgrade. I saw Vince's HID set up done and it was a HUGE improvement over my stock set up. His ability to see in the snow was way better then mine.
 
Autopal housings are typically the way to go guys, then throw a H4 kit inside and your set!! Big difference in lighting!
 
There are many ways to make it work...
sy9qgy.jpg
 
well i suppose physically it would be possible. but you could also swallow a flashlight and shit rainbows.. each is just about as likely to work.
 
You must log in or register to reply here.

Similar threads

blondejoncherokee
can anyone can grab 2 tikis for me in orange? Norcal NAXJA guy asking
Replies
3
Views
453
JohnX
JohnX
S
All D30 lockers the same?
Replies
9
Views
468
RCP Phx
R
B
Black soot coming out the exhaust?
Replies
9
Views
414
cruiser54
C
B
Dash brake light on after replacing rear brakes
Replies
1
Views
1K
RCP Phx
R
O
Brake failure light randomly coming on
Replies
4
Views
2K
RCP Phx
R
Back
Top