49erRider
NAXJA Forum User
- Location
- Fort Mill, SC
Ok let me preface this by saying last weekend I did the evap - heater core replacement on my Jeep.
2000 Cherokee 120k
All went fine got everything back together and EVERYTHING works except for keyless entry. I get nothing when I push the buttons. Power locks, work but no Keyless.
There was one connector that we left unplugged because I could not figure out what it connected to and for the life of me can not find anything near it.
The one that was left unplugged was a medium sized black connector on the steering column in the same bundle as the turn signals etc.. It is very close to the small white one and these sit further down than the turn signal connections.
Any ideas as to why everything but keyless would work?
Brad
2000 Cherokee 120k
All went fine got everything back together and EVERYTHING works except for keyless entry. I get nothing when I push the buttons. Power locks, work but no Keyless.
There was one connector that we left unplugged because I could not figure out what it connected to and for the life of me can not find anything near it.
The one that was left unplugged was a medium sized black connector on the steering column in the same bundle as the turn signals etc.. It is very close to the small white one and these sit further down than the turn signal connections.
Any ideas as to why everything but keyless would work?
Brad