project yj
NAXJA Forum User
- Location
- florida
im tryin to adapt a dana 300 to my aw4. does anyone know if anyone sells an adapter, or what i would need to do to make it work?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
dana 300 to an AW4
- Thread starter project yj
- Start date
OlyWaXJ
NAXJA Forum User
- Location
- Olympia Wa
What you have to do is mechine the input bearing adapter(on the 300).You need to remove the area where the seal is.Then you replace the input bearing with a sealed one.
Then if you use a clocking ring(I think it needs to be 3/8th thick).I just made my own spacer as I didnt need to clock.
You will need to "hog" out a couple holes in the adapter thats on the trans.
OlyWa
Then if you use a clocking ring(I think it needs to be 3/8th thick).I just made my own spacer as I didnt need to clock.
You will need to "hog" out a couple holes in the adapter thats on the trans.
OlyWa
OlyWaXJ
NAXJA Forum User
- Location
- Olympia Wa
You can see the hole's I had to open up here,
I have some somewhere of the bearing retainer and spacer I'll see if I can find them.
OlyWa
I have some somewhere of the bearing retainer and spacer I'll see if I can find them.
OlyWa
