Hello Jeep enthusiasts!
I´ve been installing the "Ultra Start G11-XR Keyless Entry & Remote Auto Starter System" today on my 1989 Jeep Cherokee Laredo (automatic)
Im using this chart:
http://www.the12volt.com/installbay/alarmdetail/1150.htmlo
and so far i´ve got the remote start to work just fine.
HVAC and stereo comes on with it.
However I cant for the life of me get the door lock/unlock system to work.
The system has a negative output for door lock/unlock, so I connected a relay to reverse polarities, connected the + output to my Jeeps relay (light green and tan wires going to relay) but nothing happens.
So I measured those - outputs from my remote start and the appear to show a 7v constant and when I hit the lock (or unlock) button it briefly shows nothing, 0.
Is it possible my Ultra Start system is out of order??
Am I doing something wrong?
I sincerely hope someone out there will know anything :dunno:
I´ve been installing the "Ultra Start G11-XR Keyless Entry & Remote Auto Starter System" today on my 1989 Jeep Cherokee Laredo (automatic)
Im using this chart:
http://www.the12volt.com/installbay/alarmdetail/1150.htmlo
and so far i´ve got the remote start to work just fine.
HVAC and stereo comes on with it.
However I cant for the life of me get the door lock/unlock system to work.
The system has a negative output for door lock/unlock, so I connected a relay to reverse polarities, connected the + output to my Jeeps relay (light green and tan wires going to relay) but nothing happens.
So I measured those - outputs from my remote start and the appear to show a 7v constant and when I hit the lock (or unlock) button it briefly shows nothing, 0.
Is it possible my Ultra Start system is out of order??
Am I doing something wrong?
I sincerely hope someone out there will know anything :dunno: