I just got my powertrax lock-right locker (P/N 2310S2).
I am hoping to install it in the rear axle of my 1989 XJ. I believe the rear axle is a Dana 35, non c-clip, 27 spline, 3.08 ratio. The part number stamped on the axle tag is 53003516.
Given its a non-c-clip axle (if I am right), there is a possibility that the ring gear is too thick to slide the pinion shaft out, which means I will have to take out the carrier.
Anyone know if that is true? And, anyone done this on this particular axle and have any hints or tips?
I am hoping to install it in the rear axle of my 1989 XJ. I believe the rear axle is a Dana 35, non c-clip, 27 spline, 3.08 ratio. The part number stamped on the axle tag is 53003516.
Given its a non-c-clip axle (if I am right), there is a possibility that the ring gear is too thick to slide the pinion shaft out, which means I will have to take out the carrier.
Anyone know if that is true? And, anyone done this on this particular axle and have any hints or tips?