headbolt torque?

just did a quick search and found no torque specs. im in a hurry to get this head on, as i have a run to get too tommorow morning. and i still need to go get my tires mounted.

110 foot pounds except the front drivers side. coat those threads lightly with thread sealer and torque it to 100 ft lbs

what about the rockers? i heard 19 ft lbs, but i came across two different specs while searching. to install the rockers bring engine to tdc. check intake pushrods to make sure they are level, and torque.?? is that right? thanks

whats the process? my chiltons says its a three step process. i dont meant the torque seqence(i have that). it says theres a step a,b, and c??

norcalchris said:

whats the process? my chiltons says its a three step process. i dont meant the torque seqence(i have that). it says theres a step a,b, and c??

Click to expand...

Cylinder head screws are usually torqued in stages anymore - and I tend to do it even when the manual says nothing about it.

I'll run the pattern to 50-75-100-110 pound-feet (skip driver's front on the last run,) and I've not had any trouble.

For the rocker pivot screws, I do 19 pound-feet with the valve closed. No preload or "lash" adjustment needed.

You can find torque specs on my site - culled from FSMs - in the Tech Index.