2000bluexj
NAXJA Forum User
- Location
- Mass
I have the RE 1600 Tracbar. I need to replace the bushing on the axle side. Anyone know if I can get a bushing at a parts store that will work?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
RE Tracbar Bushing
- Thread starter 2000bluexj
- Start date
- Location
- Minneapolis, MN
RE will sell you a replacement RE bushing. If you have access to s decent press, a stock rubber bushing will fit the RE1600 tack bar.
2000bluexj
NAXJA Forum User
- Location
- Mass
can i pound one in with a hammer?
2000bluexj
NAXJA Forum User
- Location
- Mass
Deadman 94 xj
NAXJA Forum User
- Location
- Pittsburgh, PA
It's a yj bushing. You can also get it from http://www.energysuspensionparts.com/ which is where RE get's theirs'. I can't remember the P/N though. Call RE.
2000bluexj
NAXJA Forum User
- Location
- Mass
already ordered one. But its a YJ tracbar bushing?
Deadman 94 xj
NAXJA Forum User
- Location
- Pittsburgh, PA
That's what I was told by RE when I needed it. The problem was that nobody had the yj bushing.
2000bluexj
NAXJA Forum User
- Location
- Mass
huh. It would be nice to be able to buy one at a parts store if ya need one on a trip or something.
snail
NAXJA Forum User
- Location
- North Jersey
pressing it in with a bench vise should work and would be easier id think. same concept as pressing a bushing into a shock eye id imagine
