xj9140
NAXJA Forum User
- Location
- Sacramento, CA
Has anybody used a right hand drive mail jeep steering knuckle for high steer?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
mail Jeep high steer
- Thread starter xj9140
- Start date
themud
NAXJA Forum User
- Location
- Scottsdale AZ
wrong dana 30 and most are 2wd as its just a beam axle not worth the trouble if you going to go to the trouble of switching knuckles just do a wj swap...
themud
themud
RCP Phx
NAXJA Forum User
- Location
- Phoenix,Az
Also the knuckles are the same on a RHD set-up,only the draglink is different.
http://www.naxja.org/forum/showthread.php?t=1009538
http://www.naxja.org/forum/showthread.php?t=1009538
xj9140
NAXJA Forum User
- Location
- Sacramento, CA
I'm wanting the knuckle from a jk mail/RHD jeep. I'm currently running wj knuckles.
MoparManiac
NAXJA Forum User
- Location
- Amherst, NH
Then you'd want the RHD knuckle from a WJ.
I looked into this a little and read about untolerable ackerman angles from the resulting steering geometry. I don't know that I would recommend it or advise against it as I didn't collect enough information on the subject. You would, however, be able to run an inverted-T setup and have the equivalent of high steer.
