quick AX15 question

I'm replacing my worn out 1997 AX15 with a 1993 AX15. At the same time I will be doing a new clutch. Is it as simple as swapping bell housings and slaves? Are all AX15s the same or do some years need different parts? Just trying to narrow down the possible dead ends as this is my DD and I will be doing this over a weekend. Thanks for any input gents.

I will say yes--keep your 97 bellhousing and slave(or replace it) and pivot. Buy some mt90 and a new pilot bearing.

Thanks gradon.

And while you're in there, clean and grease the input shaft and the pivot joint(be gentle with the pivot clip when removing)--will make for a nice pedal feel.