mizedog
NAXJA Forum User
- Location
- Falcon, CO
I'm interested in moving my ARB switches to the coin tray location on my '01 XJ. Does this insert just pop out, or is there a hidden screw somewhere?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
How to remove stock coin tray?
- Thread starter mizedog
- Start date
CharlesS
NAXJA Forum User
- Location
- Quezon Province, Philippines
There was a factory option where the ash tray was done away with and the switches for heated seats were installed....
The console on my 98 has been out several times over the years...
Most recently for removing the shifter on my manual transmission when I replaced the clutch, but I cannot remember whether there are retaining clips or just plastic tabs holding the ash tray in place....
Just looked in the 1998 FSM and there is no reference as to how it is attached....
I have seen that location used for ARB switches several times before.... so its not very difficult to remove...
The console on my 98 has been out several times over the years...
Most recently for removing the shifter on my manual transmission when I replaced the clutch, but I cannot remember whether there are retaining clips or just plastic tabs holding the ash tray in place....
Just looked in the 1998 FSM and there is no reference as to how it is attached....
I have seen that location used for ARB switches several times before.... so its not very difficult to remove...
Talyn
NAXJA Forum User
- Location
- Radford, Communistwealth of Virginia
It should just pop out.
nobutada55
NAXJA Forum User
- Location
- Peabody, MA
push it towards the dash board and lift it up at the same time
