https://www.metalcloak.com/Wrangler-Oil-Pan-Skid-Plate-p/2701.htm I have this skid on my TJ, and the site says it MAY fit XJs. The exhaust is different on the XJ, so may be an issue at the trans. I have the AW4 on a 97. Just wondering if anyone has used it?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Metalcloak oil pan skid
- Thread starter sls97xj
- Start date
TJPRETENDINGTOBEXJ
NAXJA Forum User
- Location
- Lakeside, CA
The way it bolts on it looks like it'd be fine. I like the design though, so, please tell us if you do it! I'd buy one for my xj as well!
Sent from my SM-G930V using Tapatalk
Sent from my SM-G930V using Tapatalk
XJensen
NAXJA Forum User
- Location
- Sacramento
Engine oil pan is not typically and issue from my experience. The transmission pan on the other hand....
- Location
- San Diego
Sure you could get it but like stated, cherokees oil pans aren't in harms way like they are on wranglers.
TRCM
NAXJA Forum User
- Location
- Newport News,VA
Why would it be any different on a wrangler than an XJ ??
engine & axle are in the same places in relation to each other......
- Location
- San Diego
no.
the engine on a cherokee sits considerably further forward in relation to the axle than a TJ. and higher.
the net result is that the oil pan is a bit safer.
- Location
- San Diego
the problem I have with these types of skids is that if you hit them hard enough you'll end up probably damaging the bellhousing and the block where it mounts.
burntkat
NAXJA Member #1145
- Location
- Charleston, SC
Exactly
Much better to pull the oil pan and weld a plate directly to the bottom of it, if you're worried.
RCP Phx
NAXJA Forum User
- Location
- Phoenix,Az
Plus, they use the 42RE trans which is bigger and hangs lower.
TRCM
NAXJA Forum User
- Location
- Newport News,VA
Ok....would not have thought that from looking at them
Similar threads
