• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Chrysler 8.25, 4.56, detroit, yukon shafts

JohnX

JohnX

Sarge
NAXJA Member
Location
Williams AZ
I will post some pictures in the morning. Basically a well polished 8.25, raised shock mounts, full case detroit locker, 29 spline yukon alloy shafts, new yukon gears...just installed today, new bearings as well. Comes complete drum to drum with parking brake cables. Ready to install. I ran 33's and 35's on the locker and shafts for the last 2 years, probably around 8k miles. The gears and bearings are brand new. The brakes work well, but need new linings soon. I can also install on a saturday or sunday for a little extra.

$600 in your truck as is.

$800 under your XJ with new rear brakes ready to drive away.
 
89kirvc.jpg

7yez3wp.jpg

8gioc49.jpg

6llmst5.jpg
 
jjmat3 said:
Is that spare shaft a yukon too or stocker? If it was January and I had my 4.10 D30 & 8.25 axles sold I would be all over this. UGH. Timing sucks as usual..... story of my life.
Click to expand...
What are you asking for yours ?
 
You must log in or register to reply here.

Similar threads

kcox506
D30 LP and 8.8 4.56 Yukon Gears w/ Install Kits and Trutrac LSD
Replies
0
Views
2K
kcox506
kcox506
C
Need help reassembling Chrysler 8.25 rear axle...
2
Replies
27
Views
4K
Anak
Anak
U
Steering/Stock Axles/Brakes/Etc
Replies
5
Views
380
jeep ride
J
K
XJ Overland build plan, need a sanity check.
Replies
16
Views
6K
jeep ride
J
Skipper51
Chry 8.25
Replies
2
Views
248
Skipper51
Skipper51
Back
Top