• NAXJA is having its 18th annual March Membership Drive!!!
    Everyone who joins or renews during March will be entered into a drawing!
    More Information - Join/Renew
  • Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Dual Booster upgrade fittings

DanDXJ

NAXJA Forum User
Location
Raleigh, NC
I am putting a dual booster in a 90 XJ. Things are going fine. I can use the four existing MC to PV lines ( 2 from old set up and 2 from the new MC ) but in order to join them I need 2
7/16 in -24 to 1/2 in-20 female unions. I have look ( NAPA,Edelmans, Inline tube,etc) but can not find these listed. Has any one else done this and where did you find the unions ? I was trying to get around making new lines with metric on MC end and SAE on the PV end.
Thanks
 
Understood - I was trying to avoid buying tubing and fittings, bending and flaring. With the configuration I have if I had the unions I would be done.
 
No need to buy anything. Sounds like you have both sets of brake lines so you cut the ends off each and swap fittings. Bend it to fit and flare it with a flare tool you get on loan from your local auto store.
 
Back
Top