chad
NAXJA Forum User
- Location
- lancaster, CA
Sat. I installed some Trailmaster drop brackets and RE braces on my 2000 with a RE 4.5" lift with 1 3/4" spacers. Everything went on pretty good, I put everything together loose and then torqued it all down together. My question is, where the brackets meet the braces only the outside edge is butted up tight, the inside edge has about a 1/8" gap even though the two inside bolts are as tight as I felt I could tighten them without them breaking. Is this normal? Should I put a couple of washers in the gap so there is no freeplay as things flex? Or did I just do something wrong? Thanks in advance,
Chad
Chad