gw204
NAXJA Forum User
- Location
- St. Leonard, MD
Was flushing out the cooling system in my '00 this afternoon by disconnecting the top radiator hose (ran it to a bucket) and filling the radiator via the cap while the engine was running. I had the heater on high while I was doing this and when I shut the Jeep down I noticed it was no longer blowing any air. It won't blow on any setting. High, low, A/C, heat, defrost... So, I started checking fuses thinking I may have gotten something wet but they all seem to be fine. I don't think it was a failure of the motor itself as it never gave any signs of going out. I found reference to the resistor, and how the fan should still work on high so I don't think it's that either.
I did get overflow from the radiator fill port and some from the inlet on the pass side, but I didn't see any electrical components in the path of that water. I think I also splashed some on the connectors against the inner fender by the air box, but it wasn't a lot.
Any ideas? I'm going to pull the blower and check it next...
Thanks.
I did get overflow from the radiator fill port and some from the inlet on the pass side, but I didn't see any electrical components in the path of that water. I think I also splashed some on the connectors against the inner fender by the air box, but it wasn't a lot.
Any ideas? I'm going to pull the blower and check it next...
Thanks.