DanMan2k06
NAXJA Forum User
- Location
- Damascus, MD
4Speedfunk, to answer your Q's:
This is from a '99 Classic XJ with Dana 35.
-54 tooth count
-2.675" OD (+/- about .002", it would jump between 2.674 and 2.677)
-1.702" ID (probably supposed to be 1.700. It would jump between 1.700 and 1.704)
-Overall ring thickness of the ring ranges from .507" to .518", depending on where you measured. It would definitely be safe to call them .5" even for our project at hand.
-There's a little chamfer on one side of the ID of the ring. This measures 1.850", but I don't think it has any value to your application.
This is from a '99 Classic XJ with Dana 35.
-54 tooth count
-2.675" OD (+/- about .002", it would jump between 2.674 and 2.677)
-1.702" ID (probably supposed to be 1.700. It would jump between 1.700 and 1.704)
-Overall ring thickness of the ring ranges from .507" to .518", depending on where you measured. It would definitely be safe to call them .5" even for our project at hand.
-There's a little chamfer on one side of the ID of the ring. This measures 1.850", but I don't think it has any value to your application.
Last edited: