1987Comanche
NAXJA Forum User
- Location
- NC
Is it possible to remove the outer & inner axle shaft on the RH of the Dana 30 CAD (1990 4.0) and replace them with a 1 piece axle shaft from another Dana 30, say a Select-Trac equipped XJ with a non CAD Dana 30?
If this isn't possible are there any negative side effects to moving the slip ring to the engaged position permanantly (vibration, excessive wear, etc). I'm not really looking to do an entire axle swap at the moment but would like to make the 4WD work again.
If this isn't possible are there any negative side effects to moving the slip ring to the engaged position permanantly (vibration, excessive wear, etc). I'm not really looking to do an entire axle swap at the moment but would like to make the 4WD work again.