View Single Post
  #8  
Old October 19th, 2017, 07:04
Anak's Avatar
Anak Anak is offline
Mostly Harmless
 
Join Date: Sep 2013
Location: SoCal
Posts: 2,417
Re: Pre-Production Sneak Peak at Boostwerks Comp Mount

I believe both were OEM arms.

Note that it was not that the arms were loose. Just that the amount of effort required to remove the nut was substantially less than what I anticipated. They felt like they were only torqued to 50 ft/lbs or so, certainly not even 100 ft/lbs.

On my own I was not trying to remove the pitman arm, just replacing the nut. On AJ's we were trying to remove the pitman arm. It was certainly not loose. I was spreading the jaws on a Craftsman 17mm wrench trying to get the puller to break it loose.

I think in both cases some settling has occurred in transit. That lockwasher is a good spring, and a torque check isn't going to be a bad idea.
__________________
Project "Scope Creep": 1996 4wd 4.0L, AX15
Reply With Quote