Where to Start?

Just installed 3" lift. Of course I got the wobble, and noticed my lower lca mount is severely bent (Just acquired xj a few weeks ago). I know my axle is now off center due to the lift. Camber, Caster, and Tow are likely off as well. My plan is to have some new LCA mounts welded on, then buy an adj. track bar before having my alignment work done. Is the right way to go about this? Feedback and suggestions welcomed.

There are lot's of ways to start, but here is how to finish. http://www.go.jeep-xj.info/HowtoAlignment.htm Do an alignment instead of "having your alignment work done". By the way, forget about camber. That is only adjustable by bending the axle. Get the adjustable track bar in and center the axle. Get the castor dialed in, probably with adjustable control arms, then fine tune the toe-in.

FYI, camber can be changed with adjustable ball joints.