Exhaust Made Easy

[Alienspecimen]

I admit, I don’t like to work more than I have to. My motto is “Best way is the laziest way”…
I was worried that I wont have enough overlap to when installing my new catback, so instead of cutting it with a sawzall, I “invented” this tool to make my job easier:
http://i77.photobucket.com/albums/j54/alienspecimen/exhaust/PICT1620.jpg

I used an old screwdriver to make it
Here is how it started:
http://i77.photobucket.com/albums/j54/alienspecimen/exhaust/PICT1621.jpg

A few minutes later, I was at this point and ready to take off the muffler:
http://i77.photobucket.com/albums/j54/alienspecimen/exhaust/PICT1623.jpg

Thats all, use it.
Boris

[rocklandxjer]

cool...

[Rev Den]

gee...what a great idea...if only someone had thought of that....wait a min...they did...

http://www.mytoolstore.com/kd/2073.gif

Rev

[CopperTop]

gee...what a great idea...if only someone had thought of that....wait a min...they did...

http://www.mytoolstore.com/kd/2073.gif

Rev

Yep, I have one that goes on my air chisel, cuts like buttah

[Alienspecimen]

gee...what a great idea...if only someone had thought of that....wait a min...they did...

http://www.mytoolstore.com/kd/2073.gif

Rev
If I knew what you know at the time wnen I needed to know it...

[falcon556]

If I knew what you know at the time wnen I needed to know it...

Hey, you did good.
You had a problem, you found the solution, you shared it.
It took me a long time to figure my problem with my binding drive shaft, only to find out that
others already knew, never bothered to share.