-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Leaking washer fluid
- Thread starter Dest
- Start date
- Location
- La Habra, CA
Through the wheelwell. Pull the liner down to get to the bottle.
RichP
NAXJA Forum User
- Location
- Effort, Pa
Save yourself some grief, just bite the bullet and jack it up, then REMOVE the liner, take out ALL the push thingys and set the liner aside. Panel removal tool comes in really handy here, I was able to re-use all my panel retainers.
I just changed the pump, tried just working my hand up there, no go, tried removing just some of the push retainers, no go, finally I just got the floor jack out, lifted it till the front wheel started to come of the ground and went from there.
If you leave that one down in the front bottom attached you will fight it for 20 minutes trying to get the liner back in and will end up removing it anyway LOL....
I figure I wasted 20 min screwing with it before I just did it right.
I just changed the pump, tried just working my hand up there, no go, tried removing just some of the push retainers, no go, finally I just got the floor jack out, lifted it till the front wheel started to come of the ground and went from there.
If you leave that one down in the front bottom attached you will fight it for 20 minutes trying to get the liner back in and will end up removing it anyway LOL....
I figure I wasted 20 min screwing with it before I just did it right.