longshot but i need a passenger waggy 44 shaft

[shortxjdoug]

i know its a longshot but i need a longside waggy shaft from an 82 (widetrack i believe) its a driver drop axle any help would be appreciated the yards are bare of waggys out here

[dave92cherokee]

If nobody else can help ya out I'll check the local yard friday and see what they have and how much. I was there a while back and think i remember seeing a waggy sitting off to the side.

[Ghost]

Inner or outer? I have a set of inners I think.

[shortxjdoug]

Inner or outer? I have a set of inners I think.

need both, it lunched the joint and took both shafts with it...

dave92 that would be awesome if you came across one the yards are bare of wags out here lately

[Ghost]

My front 44 had stubs on it from a ds drop waggy axle. I still have the inners. I may have what you need.

[shortxjdoug]

My front 44 had stubs on it from a ds drop waggy axle. I still have the inners. I may have what you need.

awesome... any 19 spline half ton outer will do its just that specific wag inner thats proving hard to find

[Ghost]

awesome... any 19 spline half ton outer will do its just that specific wag inner thats proving hard to find

What is the length?

[shortxjdoug]

32.12 inches from u joint center to end of axle spline... thats warns spec measurement on it

[SmkyMtn4x4]

I have an inner and outter from an early 70's passenger drop waggy. It measured roughly 33.5" end of splines to center of u-joint. I know it's a little longer then what you are looking for, but if you think you can make it work I'd get rid of it cheap. Plus i'm here in Knoxville. Let me know if you wanna come by and look at it.

Steve