bobfortier
NAXJA Forum User
- Location
- Thetford Mines, PQ Canada
Hi
I found this
http://www.twisted-halo.com/digicam/xj/Bumper mount.pdf
and I have a couple of questions. First, I assume that the holes must be 1/2 inch in diameter ?
And also, I found in my pile a piece of 34 x 6 x 3/16 thick. Can 3/16 work for a winch bumper mount ? I saw a lot of people using 1/4, but because I have the piece on hand I'm just asking.
Thanks
I found this
http://www.twisted-halo.com/digicam/xj/Bumper mount.pdf
and I have a couple of questions. First, I assume that the holes must be 1/2 inch in diameter ?
And also, I found in my pile a piece of 34 x 6 x 3/16 thick. Can 3/16 work for a winch bumper mount ? I saw a lot of people using 1/4, but because I have the piece on hand I'm just asking.
Thanks