-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
All xj dana 30 knuckles the same?
- Thread starter 89jeepxjw
- Start date
Root Moose
NAXJA Forum User
- Location
- ON, Canada
What year is your Jeep?
IIRC ~1990 and up (or is it 87 up?) are the same.
The early knuckles have a two piece design involving the brake pad carrier. As long as you ask for anything in the 90s you should be good to go. Fairly certain TJ and ZJ will work as well. Don't know about YJ.
IIRC ~1990 and up (or is it 87 up?) are the same.
The early knuckles have a two piece design involving the brake pad carrier. As long as you ask for anything in the 90s you should be good to go. Fairly certain TJ and ZJ will work as well. Don't know about YJ.
- Location
- Lakeside, CA
90 and earlier were separate brake caliper bracket. Stick with an 87-90.
- Location
- Roanoke VA
If you do that you have to run the earlier uni-bearings as I understand it. 90+ are all the same.
Root Moose
NAXJA Forum User
- Location
- ON, Canada
Ask for anything 91 up.
cherokee chuck
NAXJA Forum User
- Location
- freeland,wa usa
Calipers fit 90 & later, that is what changes in the knuckle. They also changed the unit bearing, but I believe it will still fit the knuckle if you use the correct rotor. It's kind of confusing because 90 is still the Renix motor. 90 must be the first year for the change from AMC to Mopar.