Pulled Code 14

[jeepmadness]

Map sensor electrical 91 laredo 4.0.

any one have a write up how to test the Map sensor circuit. I pulled this off of internet for a dodge 96. Don't know if it is the same.

http://autorepair.about.com/library/faqs/bl917d.htm.

I visually inspected all wiring. Car does not hold idle. I cleaned out the IAC. the only code that shows up is 14. I think the map sensor would cause the problem?

[Kuasimodem]

Yep, those are the correct voltages and pins on the MAP sensor itself. Also, make sure that the vacuum line from the sensor to the manifold is not cracked

[jeepmadness]

Just want to make I measured output correctly.

Input just used connector c (+) and a (-)measured 5 volts.

for output I connected only the c portion with the connector
connected b (+) in Map and a (-) on connector no reading

If i did it correct map is bad?