Torque specs for steering stabilizer tie rod bolt?

[Trout]

Does anybody have the torque specs for that pressed in bolt for the steering stabilizer? The bolt that goes through the tie rod..
Thanks in advance...

[anony91xj]

Gootentight.

I forget if there's a cotter pin on that or not, but if there is, tighten it down good, line up the hole in the stud with the slot in the nut, and put the pin through.

[Kittrell]

What he said, it's the SS, torquing it down correctly is pretty useless. Just get it on there good and tight..............:thumpup:

[Trout]

Thanks guys! My replacement doesn't have a hole for a cotter pin, however, it does have a lock washer to go on under the nut! I was just curious about the torque specs for that bole. Good n' tight sounds good to me.
Thanks again.