anyone in the Jersey area know how to do an R&P in a dana 30 & 35

[ybreal210]

i figure i might as well get out and ask around, im looking to change my gearing in my dana 30 & 35s, im currently running the stock 3.55 and wanted to go up to a 4.56 in both to help turn my 35" boggers a little bit easier.... I'm not to well understanding of how to do everything to set them up, was hoping i could find someone who would be willing to help me out a little bit so i dont have to spend an arm & leg at a shop to have them done..... i can do just about everything else to my jeep, but when it comes to rears i so far have only done lockrites in both rears myself and fluid changes, dont know anything else..... if anyone in NJ can help it would be appreciated.... thanks in advance....
-Brandon

[goodburbon]

I don't know about that, but for the same price may I reccomend

http://cgi.ebay.com/ebaymotors/Rear-Dana-44-Jeep-Cherokee_W0QQcmdZViewItemQQcategoryZ33731QQihZ016Q QitemZ260024221338QQrdZ1QQsspagenameZWDVW

instead?

[OverlandXJ]

Brandon, give Jack at No Excuses in New Egypt a call....he's not far from you and he has a very reasonable price on gearing.

Tell him John B referred ya.

1-800-923-JEEP

[warpigxj]

your on the jersey devil board right?? if so pm ibadzj(matt) he doing my axle swap

[rocklandxjer]

he doesnt want to pay an arm and a leg, why would he want to spend 300 on a 44 AND have to pay to have that regeared, they have 3.54 in em.

althoughhhh, dude, 35s on a dana 35 with a lockrite.. you might as well pay for the 44 cause if you wheel that thing hard youre going to snap shafts like crazy...

[ybreal210]

<knocking on wood>.... i've wheeled this thing pretty hard so far and havent broken anything other than a ujoint on the driveshaft....... im happy with my 35 for now.....