Here is my idea:
cut two lengths of steel
drill and tap the ends for TREs
drill a whole for the drag link connection (very much like the factory setup)
Would this work? I was thinking this would allow me to replace the TRE on the draglink instead of the whole draglink. I did some searching but didn't see this mentioned. Thanks in advance!
cut two lengths of steel
drill and tap the ends for TREs
drill a whole for the drag link connection (very much like the factory setup)
Would this work? I was thinking this would allow me to replace the TRE on the draglink instead of the whole draglink. I did some searching but didn't see this mentioned. Thanks in advance!