RWKHausSupply
August 22nd, 2006, 18:53
I got my ECTED adn made a set of setup bearings and setup the new locker in a new to me housing yesterday. Then today I bought a set of new bearings nd put it all together and went to check the contact pattern one last time before calling it done.
Well it shows the pinion is too shallow. The problem for me is that my bearing separator is too think to get between the Bearing and the solenoid collar on the ECTED adn it says to not use a spreader specificly in the install manual due to that.
So anyone have a carrier bearing puller that they would let me bring my carrier by and pull this bearing offf and while we are at it might as well just pull the pinion bearing off the pinion (again) for me I will take it from there. About 15 min of your time I would think..
Thanks.
Rob
Well it shows the pinion is too shallow. The problem for me is that my bearing separator is too think to get between the Bearing and the solenoid collar on the ECTED adn it says to not use a spreader specificly in the install manual due to that.
So anyone have a carrier bearing puller that they would let me bring my carrier by and pull this bearing offf and while we are at it might as well just pull the pinion bearing off the pinion (again) for me I will take it from there. About 15 min of your time I would think..
Thanks.
Rob