xj_mike
NAXJA Forum User
- Location
- San Diego, CA
I have searched but really did not find a good answer. I am plumming in an aux. tranny cooler and bypassing the stock radiator one.
The rubber lines route better if I put the line from the tranny (output) into the lower inlet on the cooler and the upper outlet from the cooler to the line back into the tranny (input).
In the past I always would put the line from the tranny into the top and back to the tranny from the bottom.
Does it really matter which way it flows through the cooler?
The rubber lines route better if I put the line from the tranny (output) into the lower inlet on the cooler and the upper outlet from the cooler to the line back into the tranny (input).
In the past I always would put the line from the tranny into the top and back to the tranny from the bottom.
Does it really matter which way it flows through the cooler?