rockwerks
NAXJA Forum User
- Location
- Chito Beach Resort, WA
Ive seen one of the sites that had steering tre adapter studa tapered to fit stock knuckle taper and a 5/8" stud on the other end for heim joints any one remember the site?:dunno:
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
TRE to heim adapter stud?
- Thread starter rockwerks
- Start date
markaboo929
NAXJA Forum User
- Location
- Mooresville,NC
found this in 1/2 inch-could use with an adapter if you are using a 3/4 hiem joint.
http://www.speedwaymotors.com/p/555,296_Tie-Rod-Conversion-Kit.html
http://www.speedwaymotors.com/p/555,296_Tie-Rod-Conversion-Kit.html
markaboo929
NAXJA Forum User
- Location
- Mooresville,NC
sorry more searching found this instead--my bad.....:speepin:
http://www.speedwaymotors.com/p/3333,105_Adjustable-Tie-Rod-Adapter-Studs.html
hey just thought os something here--- think about it for a sec-------------now you can adjust your link that goes from the pass knuckle to the pitman arm to be even with the trac bar,to totally eliminate bump steer.???
http://www.speedwaymotors.com/p/3333,105_Adjustable-Tie-Rod-Adapter-Studs.html
hey just thought os something here--- think about it for a sec-------------now you can adjust your link that goes from the pass knuckle to the pitman arm to be even with the trac bar,to totally eliminate bump steer.???
vetteboy
NAXJA Forum User
- Location
- morganville, nj
IDJeepGuy said:
Nah, typically no one runs steering heims in double shear...there are a couple guys that have made some custom arms to do it, but it's not common.
That being said - the product pictures there looks TERRIBLE for what we'd use it for. Keep in mind that its specified application is "pinto". :eyes:
markaboo929
NAXJA Forum User
- Location
- Mooresville,NC
uh that would be for a pinto style knuckles on a street rod-made from chrommoly-----------------just a thoguht did ya see the chevy style that was offered as well-no comment there:kissyou:
vetteboy
NAXJA Forum User
- Location
- morganville, nj
markaboo929 said:
Yeah, I guess you're right. Having a heim joint in single shear 3" away from the knuckle is a great idea.
markaboo929
NAXJA Forum User
- Location
- Mooresville,NC
it WAS just an IDEA............I dont think to well sometimes----wouldnt actually do it either though:spin3:
rockwerks
NAXJA Forum User
- Location
- Chito Beach Resort, WA
Found these last night. bottom of the page, they make them for about any application.
http://www.ubmachine.com/balljoints.html
Im thinking the 40-4185-A is just the ticket, any thoughts?
http://www.ubmachine.com/balljoints.html
Im thinking the 40-4185-A is just the ticket, any thoughts?
