• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

8.25 gear install

Yep,that or the correct spanner wrench!
 
No need to spend that kind of coin. Last one of those I made was just electrical conduit with a big nut welded to the end and another chunk for a t-handle. Only problem, I only made one. It's so much easier to have two and just leave one laying in each axle tube while you're roughing in the setup.
 
Yeah, scrap bit of pipe with a front hub nut welded to one end and a bolt welded in the other end to attach a torque wrench. An hours work maybe, including painting it!
 
You must log in or register to reply here.

Similar threads

W
Build thread: daily driven tow rig
4 5 6
Replies
117
Views
10K
Woodswanderer
W
Jeepguy91
Misc truck and jeep parts
Replies
5
Views
748
chuck619120
C
RWKHausSupply
$375 - Chy 8.25, Dana 30, 35, 44 - Front & Rear Gear sets & Full Better Master kits
Replies
8
Views
2K
RWKHausSupply
RWKHausSupply
L
What Am I Hearing? Gear Noise?
Replies
9
Views
1K
LKN_xj
L
N
New XJ owner - need advice, can't decide on mods??? (PICS)
2
Replies
32
Views
3K
Evan03
E
Back
Top