Raising exhaust 1/2" for skid

How do you do it? I have rusty's oil pan/tranny pan skid and the bracket is hitting the exhaust pipes next to the driveshaft. The directions on rusty's site aren't clear but it does state to raise the exhaust some or adjust it. Do i unbolt it where it connects to the headers and shove it up some more?


or just cut it off :guitar:

are your motor mounts shot?


Do you have a transfer case drop?

I am an idiot. The transfer case drop lowered the exhaust. I was staring at the source of my problem for 2 hours without even noticing. I'm getting my sye kit this week so i'll just wait till then and install it with the exhaust up where it belongs. :twak:

sorry for wastin your time.