upper control arms

[1sickhick]

does any one know the what the length of the upper control arms should be for a 5" lift?I'm trying to build my own.

[mud1059]

I used my stock ones for 4.5". Worst case scenario make it only a bit longer. If you're going through the hassle of making uppers, you might as well buy a crossmember and make your own longarms. Just my humble opinion. Grand total you should spend less than ~$5-600

[madmax]

Lift...........Lower Control Arms/Upper Control Arms
********Decimal**Fraction**Decimal**Fraction
Stock........15.75.......15 ¾........15.00.......15
2”.............15.92.......16............14.88.... ...15
3”.............16.09.......16............14.92.... ...15
4”.............16.33.......16 3/8......15.03.......15
4.5”..........16.47.......16 ½........15.11.......15
5”.............16.62.......16 5/8......15.21.......15 ¼
6”.............16.97.......17............15.44.... ...15 ½
7”.............17.36.......17 3/8......15.74.......15 ¾
8”.............17.81.......17 ¾........16.09.......16
9”.............18.30.......18 ¼........16.50.......16 ½
10”...........18.82.......18 ¾........16.96.......17

[1sickhick]

THNKY YOU.:laugh3:

[CanMan]

Why not just make them adjustable, its only a few more $$ for threaded rod and tubing inserts. My .02.