• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Baffled

C

Crush

NAXJA Forum User
Location
Florida
Ok.I attempted to search the forum for a problem I have,though some were similar none were the same.Here goes:I takes a long time for the engine to start,when it finally starts,it idles low,and rough.If I lightly touch the throttle and hold it for 30 seconds it will hold a idle at 2000 rpm and stay at 2000 rpm,If I try to bump the throttle quick the engine doesnt respond,If I idle up slow the rpms will go up.
 
stuck Idle Air Control Valve?
 
I was thinking the same thing.I cleaned it(not to say that would fix it)with the engine running I unbolted it and just pulled it out a little bit and the idle went higher
 
Crush said:
How much seafoam should I have used?
Click to expand...

When I clean a throttle body I usually pour almost all of the can slowly in and then dump the last little bit to stall the engine and then let it sit for about 15 minutes before restart.
 
You must log in or register to reply here.

Similar threads

A
Renix TPS nightmare
Replies
19
Views
3K
Saudade
Saudade
N
New Engine is Hard to Start
Replies
0
Views
34
NGThomas
N
G
Engine low on power
Replies
7
Views
2K
Gotitjr
G
S
2000 STFTs stuck at 98% ??
Replies
8
Views
2K
RCP Phx
R
9
Renix lowish idle
Replies
10
Views
1K
90xj06
9
Back
Top