mikeNtucson
NAXJA Forum User
- Location
- Tucson, Az
Wasn't there some years that the 9" rear and 44 front are a straight bolt in on the xj? Where the spring perch lines up and what nots for the front, and use the radious arms. Getting ready to go look at a 1975.5 front bronco axle, the one were nothing had been molded into the center section. Was looking to do a 44 front, using ford axle and cut to waggy width, but pass side bronco tube is like 28" and the waggy is 30" (rounded #'s) and it would be harder to add 2" then to cut off.